Deletion of Unit of Measure:ĭeletion of unit of measure is not advisable as it used centrally in all applications. UOM not maintained in other languages(create UOM in login language)Īs Unit of measurement is held centrally in the SAP R/3 System for all applications, any change will have impact in all modules.
ISO CHINESE GUN ISO
Assignment of ISO code/changing ISO codeĦ. T006A - language dépendent attributes + descriptionĬhanges in the unit of measure may be forĤ. Maintain UOM in different languages by logging to the system with different logon languageĬustomizing of UOM in SAP is basically stored in two tables: Rest of unit of measure will be the secondary unit for this ISO code.ġ2.
ISO CHINESE GUN CODE
If the same ISO code is used for more than one unit of measure, you can only flag one unit of measure as a primary unit for one ISO code. Select the ISO code for the unit and maintain Tick for primary code if that is primary unit for the ISO code. If it is based on quantity, check box should not have a tick.ġ0. Maintain the tick for Value based check box if that unit will be derived based on value. It will make this unit get displayed in F4 help for unit of measure.ġ0. Maintain the tick for commercial unit check box if that unit is used commercially. Maintain the decimal places (up to which decimal value should display) and decimal place rounding (up to which the value should be rounded off)ĩ. For example here In H unit of measure, conversion is defined with respect to S second.Ĩ. Maintain the conversion factor with respect to SI unit. Maintain the details like Measurement text, commercial name and technical name.ħ. Select TIME and then click on Units of measurement All other units under the dimension TIME is defined with respect to S (second).S is the SI unit in this dimensionĦ. Select the particular dimension under which you want create the unit as shown belowĤ. A list of the current international ISO codes for units of measurement is available on the Internet at:īusiness specific ISO codes can be created in the system if not available in the system and assigned to UOM.ģ. So it is always advised to assign ISO code to UOM. Converting the internal units of measurement into the ISO code is required for exchanging data using EDI. It is used for converting the SAP-internal units of measurement into standard units of measurement. The ISO code is important for Electronic Data Interchange (EDI). Decide which ISO code should be assigned to the unit:Īn ISO code can be assigned to several internal measurement units. Dimension helps us to group the UOMs.System will allow to create business specific dimensions but always it is advisable to create UOM under the above 7 dimensions.Ģ. Whenever unit of measurement is to be created first decide to which dimension it belongs to or otherwise UOM is created under no dimensions. There are seven base dimensions, to which all other dimensions can be traced: Length, weight, time, electrical current, temperature, molecular mass and brightness. Decide under which dimension unit has to be created: It's a onetime creation during the project phase and it used across all modules.Ĭreation/change of new unit of measure is a Global Impact change in the system.ġ. Units of measurement are held centrally in the SAP R/3 System for all applications. Unit of measure can be created using transaction CUNI (SPRO-> SAP Net Weaver-> General Settings ->Check units of measurement). These UoM's are linked with each other for every material by conversation table which is explained below in section - IV-alternative unit of measure It allows consumption, stock transfers, transfer postings, and physical inventories to be recorded in a unit differing from the base unit of measure.
0 kommentar(er)
